January 24, 2019, 09:58:47 AM

Author Topic: Modelling bits for 3d printing  (Read 53676 times)

0 Members and 1 Guest are viewing this topic.

Offline marell le fou

  • Full Member
  • *
  • Posts: 1057
Re: Modelling bits for 3d printing
« Reply #285 on: January 02, 2019, 09:06:03 PM »
Mmmm the artillery block is a little bit too bulky to me.

Looks too much like a cube with pointy bits. You have done better :)

Offline Malika

  • Full Member
  • *
  • Posts: 1205
    • Loc: Netherlands
    • Bits Blitz
Re: Modelling bits for 3d printing
« Reply #286 on: January 07, 2019, 04:27:44 PM »
That was kinda the idea I was going for when designing this artillery piece. I missed the big missile pods filled with tons of small missiles.
Bits Blitz - the place to be for all your bits needs!

Offline Malika

  • Full Member
  • *
  • Posts: 1205
    • Loc: Netherlands
    • Bits Blitz
Re: Modelling bits for 3d printing
« Reply #287 on: January 11, 2019, 03:50:09 PM »
Need more bits?

Novan Logistics Boxes (Supply Dump) - 4.00



Quote
A set of Novan logistics/equipment boxes consisting of the following:

4 x individual boxes sprues + 4 additional loose boxes
3 x stacked boxes sprues
https://vanguardminiatures.co.uk/shop/novan-logistics-boxes-supply-dump/
Bits Blitz - the place to be for all your bits needs!

Offline Malika

  • Full Member
  • *
  • Posts: 1205
    • Loc: Netherlands
    • Bits Blitz
Re: Modelling bits for 3d printing
« Reply #288 on: January 20, 2019, 08:52:11 AM »
Bits Blitz - the place to be for all your bits needs!

Offline marell le fou

  • Full Member
  • *
  • Posts: 1057
Re: Modelling bits for 3d printing
« Reply #289 on: January 21, 2019, 08:25:08 PM »
Looks like something flying :)